Victorian Consolidated Regulations

8 Reg. 9.2.1: S.R. No. 127/2000 as amended by S.R. No. 96/2005. - SECT 3.5.9.

Hazard identified in design during manufacture

3.5.9. Hazard identified in design during manufacture

If a manufacturer of plant advises the designer of the plant under regulation
3.5.12(1)(c) that there is a hazard in the design of plant for which the
designer has not provided a risk control, the designer must-

   (a)  revise the information originally supplied to the manufacturer to
        ensure that-

   (i)  the risk is eliminated so far as is reasonably practicable; or

   (ii) if it is not reasonably practicable to eliminate the risk, the risk is
        reduced so far as is reasonably practicable; or

   (b)  instruct the manufacturer, in writing, that the designer is of the
        opinion that it is not necessary to revise the information originally
        supplied to the manufacturer to ensure compliance with this Part.

Note Act compliance-section 27 (see regulation 1.1.7).