• Specific Year
    Any

PETROLEUM AND GAS (PRODUCTION AND SAFETY) ACT 2004 - SECT 639 When measurement scheme must be revised

PETROLEUM AND GAS (PRODUCTION AND SAFETY) ACT 2004 - SECT 639

When measurement scheme must be revised

639 When measurement scheme must be revised

(1) The controller of a meter must appropriately revise the measurement scheme for the meter in any of the following circumstances—
(a) the controller has installed, or proposes to install, a meter to which the scheme does not apply or that does not comply with the scheme;
(b) the making or amendment of an Australian standard or other standard that makes it appropriate to revise the scheme;
(c) the happening of an event relevant to the meter of which the controller is aware, or ought reasonably to have been aware;
Examples of an event—
a development in technical knowledge or hazard assessment
(d) proposed modifications to the meter or activities under the scheme that make it appropriate to revise the scheme;
(e) it is proposed to change competencies required for persons carrying out activities under the scheme;
(f) the controller becomes aware of a significant anomaly in the scheme;
(g) there is a likelihood of inaccurate measurements under the scheme.
Penalty—
Maximum penalty—500 penalty units.
Note—
If a corporation commits an offence against this provision, an executive officer of the corporation may be taken, under section 814A , to have also committed the offence.
(2) In this section—


"revise" means amend or remake.