Northern Territory Consolidated Regulations
[Index]
[Table]
[Search]
[Search this Regulation]
[Notes]
[Noteup]
[Download]
[Help]
MOTOR VEHICLES (STANDARDS) REGULATIONS
TABLE OF PROVISIONS
PART 1--PRELIMINARY
1. Citation
2. Commencement
3. Application
4. Interpretation
PART 2--MOTOR VEHICLES STANDARDS
Division 1--Mass limits of vehicles
5. Mass limit for wheel
6. Mass limit for tyre
7. Mass limit for axle or axle group
8. Road friendly suspension
9. Ultra low floor 2 axle route bus
10. Bus with road friendly suspension
11. Retractable axle
Division 2--Limits to laden mass
12. Laden mass of vehicle or vehicle combination
12A. Concessional mass limits for certain vehicles
13. Laden mass of consecutive axle groups
14. Laden mass of trailer
Division 3--Certain special vehicles
15. Vehicle fitted with non-rubber tyres or solid rubber tyres
16. Vehicle fitted with all or some rubber tyres
17. Tyres filled with water
Division 4--Axle group spacing for B-Double
18. Axle group spacing requirements for B-Double
Division 5--Size and projection of load
19. Front and side projections
20. Rear projections
21. Dangerous projections
22. Projection of load on motor cycle
23. Size limits
Division 6--Requirements for converter dollies
24. Converter dollies used in road trains
Division 7--Identification of road trains
25. Identification of hauling unit of road train
26. Identification of trailers used in road train
PART 3--AUSTRALIAN VEHICLE STANDARD RULES
Division 1--Australian Vehicle Standards Rules
27. Australian Vehicle Standards Rules are law of the Territory
Division 2--Exemptions from certain rules
28. Exemption from right-hand drive requirement
29. Exemption from spray suppression requirement for B-double
30. Exemption from pneumatic tyre requirement for certain vehicles
31. Exemption from ABS brakes for road trains
32. Exemption from speed-limiting requirement for road train
33. Exemption in relation to vehicle carriers
Division 3--Additional requirements in relation to certain rules
34. Rear marking plates
PART 4--OFFENCES
35. Compliance with Regulations
36. Regulatory offences
37. Defence if excess loading within certain limits
PART 5--MISCELLANEOUS
38. Certificate in relation to manufacturer's gross axle load limit etc.
39. Repeal
40. Repealed Regulations continue to apply
SCHEDULE 1
SCHEDULE 2
SCHEDULE 3
SCHEDULE 4
SCHEDULE 5
SCHEDULE 6
ENDNOTES
AustLII: Copyright Policy
| Disclaimers
| Privacy Policy
| Feedback