MOTOR VEHICLES (STANDARDS) REGULATIONS 2003
Table of Provisions
PART 1--PRELIMINARY
- 1 Citation
- 2 Commencement
- 3 Application
- 4 Interpretation
- 4A Excluded provisions
PART 2--MOTOR VEHICLES STANDARDS
Division 1--Mass limits of vehicles
Division 2--Limits to laden mass
- 12 Laden mass of vehicle or vehicle combination
- 12A Concessional mass limits for certain vehicles
- 13 Laden mass of consecutive axle groups
- 14 Laden mass of trailer
Division 3--Certain special vehicles
- 15 Vehicle fitted with non-rubber tyres or solid rubber tyres
- 16 Vehicle fitted with all or some rubber tyres
- 17 Tyres filled with water
Division 4--Axle group spacing for B-Double
- 18 Axle group spacing requirements for B-Double
Division 5--Size and projection of load
- 19 Front and side projections
- 20 Rear projections
- 21 Dangerous projections
- 22 Projection of load on motor cycle
- 23 Size limits
Division 6--Requirements for converter dollies
- 24 Converter dollies used in road trains
Division 7--Identification of road trains
- 25 Identification of hauling unit of road train
- 26 Identification of trailers used in road train
PART 3--AUSTRALIAN VEHICLE STANDARDS RULES
Division 1--Australian Vehicle Standards Rules
Division 2--Exemptions from certain rules
- 28 Exemption from right-hand drive requirement
- 29 Exemption from spray suppression requirement for B-double
- 30 Exemption from pneumatic tyre requirement for certain vehicles
- 31 Exemption from ABS brakes for road trains
- 32 Exemption from speed-limiting requirement for road train
- 33 Exemption in relation to vehicle carriers
Division 3--Additional requirements in relation to certain rules
PART 4--OFFENCES
- 35 Compliance with Regulations
- 36 Regulatory offences
- 37 Defence if excess loading within certain limits
PART 5--MISCELLANEOUS
- 38 Certificate in relation to manufacturer's gross axle load limit etc.
- 39 Repeal
- 40 Repealed Regulations continue to apply