New South Wales Consolidated Regulations

LIVERPOOL LOCAL ENVIRONMENTAL PLAN 2008 - REG 4.1

4.1 Minimum subdivision lot size

(1) The objectives of this clause are as follows:

(a) to ensure that lot sizes are consistent with the desired residential density for different locations,

(b) to ensure that lot sizes are able to accommodate development that is suitable for its purpose and consistent with relevant development controls,

(c) to prevent fragmentation of land which would prevent the achievement of the extent of development and nature of uses envisioned for particular locations,

(d) to minimise traffic impacts resulting from any increase in the number of lots on classified roads,

(e) to minimise any likely impact of subdivision and development on the amenity of neighbouring properties,

(f) to ensure that subdivision reflects and reinforces the predominant subdivision pattern of the area,

(g) to ensure that lot sizes allow buildings to be sited to protect natural or cultural features including heritage items and retain special features such as trees and views.

(2) This clause applies to a subdivision of any land shown on the Lot Size Map that requires development consent and that is carried out after the commencement of this Plan.

(3) The size of any lot resulting from a subdivision of land to which this clause applies is not to be less than the minimum size shown on the Lot Size Map in relation to that land.

(4) This clause does not apply in relation to the subdivision of individual lots in a strata plan or community title scheme.

(4A) Despite subclause (3), the size of any lot resulting from the subdivision of land shown on the Lot Size Map to be within Area 1, Area 2 or Area 3 for the purposes of:

(a) a dual occupancy that was approved before the making of this Plan and that satisfies any conditions of that approval, or

(b) multi dwelling housing, or

(c) attached dwellings, or

(d) semi-detached dwellings,

must not be less than the area shown in Column 2 of the Table to this subclause opposite the relevant Area, or if the lot adjoins a rear or side lane that provides vehicular access to the lot, not less than the area shown in Column 3 of the Table opposite the relevant Area.

Column 1	Column 2	Column 3
Area 1	225m 2	180m 2
Area 2	250m 2	200m 2
Area 3	300m 2	240m 2