CIVIL AVIATION SAFETY REGULATIONS 1998 - REG 21.607 General rules governing holders of ATSO authorisations
CIVIL AVIATION SAFETY REGULATIONS 1998 - REG 21.607
General rules governing holders of ATSO authorisations(1) An article manufacturer to whom an ATSO authorisation for the article has been issued must ensure that:
(a) the article is manufactured in accordance with this Part and the applicable ATSO, ETSO or TSO (including any deviations approved under subregulation 21.609(3)); and
(b) all tests and inspections required under these Regulations, or the applicable ATSO, ETSO or TSO, are conducted, and a quality system is established and maintained that:
(i) is adequate to ensure that the article meets the requirements of paragraph (a) and is in a condition for safe operation; and
(ii) meets the requirements prescribed by the Part 21 Manual of Standards; and
(c) the article is permanently and legibly marked with the following information:
(i) the name and address of the manufacturer;
(ii) the name, type, part number, or model designation of the article;
(iii) the serial number or the date of manufacture of the article or both;
(iv) unless subparagraph (v) applies, the applicable ATSO, ETSO or TSO number with the prefix 'ATSO';
(v) if the article was manufactured in accordance with an FAA letter of TSO design approval, the applicable TSO number with the prefix 'TSO'.
(2) An offence against subregulation (1) is an offence of strict liability.
Note: For strict liability , see section 6.1 of the Criminal Code .